intake manifold. Hold throttle wide open (engine off) and look through throttle body (flashlight may be required) and see if oil is puddled up inside manifold. If so then the intake manifold will need
...intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more ...
...you might want to check for vacuum leaks around the intake manifold. if none are present check the idle air control solenoid, and clean it out the throttle body. that would be some starting
...on dist cap. also if plugs were replaced for misfire be sure to check to see if engine is burning oil u could have bad intake manifold bellypan gasket causing ur misfire due to oil in intake ...
oil pressure drops on gauge but i just put new oil pump and screen were is oil pressure switch located back of engine behind intake manifold
...the #8 cylinder on engine. Both distributors turn in a clockwise rotation. Hope this will help you. intake plenum gasket leaks are notorious on magnums, it is on the bottom of the intake ...
...intake manifold and thus in the vacuum lines and control system. This vacuum is held there by a check valve so when you are accellerating and the intake vacuum drops you won't lose this vacuum. If ...
...Intake Manifold Air Temperature (IAT) sensor is installed in the intake manifold with the sensor element extending into the air stream: This is a Negative Thermal Coefficient (NTC), meaning that as ...
...intake manifold they had a habit of developing a leak and it can spray over towards the alternator. it is a short L shape hose from water pump to intake manifold. Also check heater hose under the ...
...intake manifold thru the firewall to the heater control panel. Check where that line attaches to the intake manifold. There is usually a stub of regular vacuum hose glued to the plastic line that can ...
Usually answered in minutes!
1,788 Questions
417 Questions
197 Questions
173 Questions
143 Questions