Questions & Answers for: Chrysler Sebring intake manifold

...need to remove the intake manifold to get at the two inboard mounting bolts to replace this part. It's pretty involved and there's a specific torque pattern to remove and reinstall the manifold

...intake manifold to operate the various vent doors. Look under the hood for the small vacuum line that goes into the firewall near the A/C lines--there may be some other ones there a different color, ...

...Intake manifold bolt torque sequence 2.7L engine Upper intake manifold with a new gasket on the lower intake manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm) Hope helps (remember ...

...INTAKE MANIFOLD BOLTS ON A 2001 CHRYSLER SEBRING 3.0L ENGINE Sorry first attempt got sent by accident Upper intake manifold bolts/nuts 168 in-lbs Lower intake manifold nuts are done in 4 steps Step1. ...

...intake manifold gasket, to do this buy a can of carburetor spray cleaner and spray around the intake, if you hear the engine idle change sound or pitch you have a leak and will need to replace the ...

...manifold off. First disconnect battery. Remove air intake. Open throttle and take slack in cables to to slide the cables out. Remove bracket. Remove two bolts on the EGR line. There are two bolts in ...

in need the torque for the bolts to the plenum the bolts that go into the plenum to the lower intake theres 7 bolts and they need to be torqued intake manifold upper and lower 89 in. lbs.

Intake Manifold Runner Position Sensor/Switch Circuit High Bank 1 Possible causes - - - Manifold flow valve harness is open or shorted - Manifold flow valve circuit poor electrical connection - Faulty

...thats stuck open I not familiar with a "intake manufacture runner control". Do you mean intake manifold? Not you sure what a runner control is though. Could give us some more detailed

...located between the two cylinder banks, it screws into the cylinder block underneath the intake manifold. In order to remove the sensor the intake manifold and right cylinder head must be removed. ...