...intake manifold and that will cost me 1,600 i just want to be sure that's the real problem.Thanks This from an owner with the same code, indeed it is the intake maniflod that causes the issue. P1004 ...
...intake manifold where it bolts to the head. The cylinder no. should be casted on the intake above each cylinder. One side should be 1-3-5 and the other 2-4-6. The firing order is also casted on the ...
...intake manifold but no antifreeze and no oil in the antifreeze could it be a head gasket? valve gasket ? itr could be or it cold just be little blow by, i would just clean it up and replace the pcv ...
...intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if you have a/c, remove harmonic balancer ,remove timing belt ...
...Intake Manifold plenum, if you are standing in front of the car, it is the sensor right before the two vacumm hoses plugged into the Intake Manifold. On 3.2L/3.5L models, the IAT sensor is ...
...intake manifold on the block (in the valley, the valley so low). Check the values of the voltage in a Chiltons or OEM book and unplug it from the rear and test it before you remove it. (Quite a job ...
...intake manifold supports.8. Remove support brackets at the intake manifold front corners and MTV.9. Loosen upper fastener attaching throttle body to support bracket.10. Remove clips attaching EGR ...
Question about 1999 300M
car stop working when the upper intake manifold cover broke how can i fix the problem? get new one from scrap yard.
where is this bleeder valve? Usually 2--1 on thermostat housing and 1 on lower intake manifold--left of center--note 4' of .250 clear hose used on bleeder to route any coolant away from drive belts.
...the air intake sensor is located on the upper intake manifold. Hope this helps and please send people to my auto-repair-website to check out all my satisfied customers.
Usually answered in minutes!
949 Questions
395 Questions
313 Questions
272 Questions
170 Questions
