...intake manifold i had bad gasket on intake manifold it got new gasket stopped leak but now engine shakes violently i need why scenarios for possible causes most likely you burned the head gasket I ...
...intake manifold gasket these are the symptoms that my car exhibited untill the motor locked up because it had filled the cylinders with water. The dex cool deteriorates the gasket and the plastic ...
...disappears , motor dos,t overheat ,could it be intake manifold gasket? A lot of GM V-6's had problems with poor intake manifold gaskets. Any moisture around the oil cap? Or anti freeze in the
intake manifold bolts ( lower ) step 1-- 62 in-lbs, step 2--115 in-lbs. intake manifold bolts/studs ( upper ) 18 ft-lbs. this is for the 3.1 v-6, have a good day! I don't think that the&
intake manifold torque specs and sequence 1998 malibu 3.1 litre Fig. Exploded view of the upper and lower intake manifold and fasteners - Position the rocker arms in their original locations and ...
...intake manifold attaching bolt and nut, then remove the housing. Fig. Remove the two housing-to-intake manifold bolts and remove the housing Remove the thermostat. To install: Clean all gasket ...
...ON THE MAP SENSOR GOES The MAP sensor bolts to the intake manifold between the intake and the coil pack. The green 3 pin connector will go right under the manifold so you have only so far you can
...intake manifold gasket. I replaced mine a few years ago and all was fine. Engines affected are the 2.4-3.1-and 3.5, look very carefully around the intake manifold and you will see it if its leaking! ...
Question about 2001 Malibu
...intake manifold bolts for a 2002 Chevy Malibu with a 3.1L need to be torqued to? Pretend the picture is lower intake manifold, that is the tightening sequence. 1st step 5 ft lbs 2nd step bolts 1--4 ...
Usually answered in minutes!
1,306 Questions
1,257 Questions
1,094 Questions
1,067 Questions
997 Questions