...intake manifold there isnt any easier work , these are a burden of my life lol , the manifold is not to bad to remove , take your time when refitting and make sure you dont over tighten manifold ...
...the air cleaner box to the intake manifold. You will see a unit with electrical connection . Hope this helps ...
...intake manifold by 3 O-ring gaskets. Push onto the back of the intake plenum near the firewall to expose a gap at the front of the intake plenum at the front intake manifold. Put 2-3 long flat ...
what is a valley plate and location on a 2004 land rover hse on the top of the engine block, underneath the intake manifold. you'd need to take out the intake manifold for access.
...intake manifold gasket My 1996 land rover discovery is acting funny. It is driving fine, but the intake manifold gasket keep sweeling under the intake. What is causing this? oil from the pcv valve ...
...intake manifold (this is the solid large plastic cover that covers the top of the engine when you remove the engine cover). There are many wires and small vacuum hoses to disconnect. Plus.., when ...
...can I find that on my car? The canaster purge valve is on the intake manifold near the mian air intake its takeing gas fumes from the tank and sending them to be burned through the main fuel ...
Question about 2001 Discovery Series II
...intake manifold gaskets, and flushed the radiator, and still having the same problem. - took it in to replace the intake manifold gaskets; - then it started overheating just after a few miles of ...
...intake manifold All vehicles are equipped with a PCV (positive crankcase ventilation) valve that is located on top of a valve cover and connected to the intake manifold with a rubber hose. When the ...
Question about 1999 Discovery
How many nock sensors does a 2004 land rover discovery II have? Is one under the intake manifold? I only see one that is on the outside of the intake.
Usually answered in minutes!
931 Questions
392 Questions
318 Questions
325 Questions
340 Questions
