where is the distributor lock down bold located usually right at base of distributor where it seats in the engine, or intake. What engine?
lots of water after start up from pipe when i havent driven it for a week or two lots of water comes out of the tale pipe no white smoke or anything lots of water you have an intake leak
...problem can cause by a lot of components. Dirty air filter Dirty injectors + o-rings Vacuum leak at intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) ...
exhaust and intake which is which on the cylinder heads on a 1984 bronco 2 2.8L? Valves always line up with the port that determines its use. Intake will line up with the runners on the intake ...
...ruff Timing, need of a tune up, head gasket, low compression.... and if it has the 2.9l V-6, the intake gasket could have been "sucked". Basically, Ford had a huge problem with intakes on the 2.9 ...
ford bronco 2 firing order diagram Try looking on the intake manifold. I've seen lots of companies stamping it right on the front portion of the stock manifold. Hope this helps
... I hooked the jumper to the starter and nothing happened. Weird thing is gas started coming out the intake. First off is it the starter and why was fuel coming out the intake? Yes unfortunately your ...
1984 ford bronco II backfires through intake and dies changed plugs and wires distributor, cap & rotar, coils, and checked timing still didnt fix problem what could be causing problem? BACK FIRING
Question about 1987 Bronco II
...things to get this done: An independent distributor that doesn't require a vehicle computer, and intake manifold with a bolt pattern that'll work with a carburetor, and a carburetor. Oh, and a ...
how do i REPLACE INTAKE MANIFOLD GASKET ON 1989 BRONCO ii bronco II eddie bauer Unbolt the Intake Manifold, install the new gaskets and bolt it back in place. My best advice to you is go to a auto ...
Usually answered in minutes!
79 Questions
354 Questions
233 Questions
196 Questions
176 Questions