Questions & Answers for: Buick Park Avenue intake

...outlet located above the water pump. The part is plastic, 90 degree elbow. You have to take the intake off in order to change..Its threaded in and the only wall to thread it in is remove

How many intake manifolds does a 1998 buick park avenue have? Also is this a difficult job to do? I have heard these cars are notorious for melting there intake manifolds, is there a metal replacment ...

i found water in my air intake. what kind of i found anti freeze in my air intake. what kind of problem am i looking at First start the car to operating temps and check all hoses for any small pin ...

leaking anti freeze from under the air intake hose under tps sensor right where the plenum and upper intake meet it appears The plastic intake upper plenum is known to warp,causing this leak.I believe

...it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues ...

coolant leaking in and around the intake manifold as well as the under carriage of that same part I think. Outake? I know that the part that attaches to the manifold appears to be metal but the ...

...piece of plastic what is the big plastic cover called? It sounds to me like you are describing the intake plenum. What on earth happened? were you spraying starting fluid in the engine or something? ...

i have an 89 buick 3.8 that misses and backfire thru the intake Like I said above--our 89 Buick 3.8 misses and backfires thru the intake. What is causing this problem? HAVE TIMING CHECKED. ...

...pipe but theres none coming from there It sounds like the gasket between your throttle body and intake is damaged, Your throttle body is water heated to assist in cold weather starting and if

need images of the intake manifold need images of the intake manifold If non supercgarged Lower torque 11 ft. lbs. Upper 89 in. lbs. see diagrams for torque sequence