Questions & Answers for: installing fascia

how do you replace headlamp bulbs on 1999 chrysler 300 You half to remove the Headlamp housing to change it. Here is the instructions out of the factory manual. Tell me if this works for you? HEADLAMP

How to take out the light assy on a 2004 Toytota sienna van.RH side. Do you have to take off the front cap (bumper) Yes....herer is the steps to replacing it: Headlight Assembly Removal & ...

Trying to change the front passenger turn light Cornering LampRemoval & InstallationTo Remove: Remove the bulb socket from the cornering lamp. Release the cornering lamp forward retaining tab and ...

How do you remove the air filter box on a 2001 Can't remove the box to get to the low beam light to replace it. How do you remove the air filter box on a 2001 300M REMOVAL Release hood latch and open ...

need to replace the headlight assembly on front passenger side do i have to take off the bumper? for ponitac vibe 2003 also have dent on the area Yes you do. This is the steps to do that to replace ...

i need to change the headlights REMOVAL PROCEDURE Open the hood. Remove the push-pin retainers that secure the top of the upper fascia and grille assembly to the upper tie bar to allow the upper ...

I am looking for a diagram of the bumper assembly for a 2004 Chrysler town & country. Hope this helps, it it does please leave feedback and vote Thank You and Good Luck Release hood latch and open

2011 Dodge Caravan. Ran into a metal wheelchair ramp rain. Drove back - dislodged - the black trim insert near the bottom of the plastic bumper cover. That black plastic thing has to be just put back ...

How do I replace my rear bumper on my 04 pacifica Open liftgate. Fig. 12   Remove two push pin fasteners per side at the liftgate tower area (Fig. 12). Hoist and support vehicle with safety ...

Where is the windsheild washer pump on a 2002chrysler Cirrus It's attached to the windshield washer tank you are probably not going to like this answer..but.. It is located in the reservoir. removal ...