...Install the window regulator assembly. Tighten the 3 motor bracket nuts to 89 inch lbs. (10 Nm). Install the 2 window regulator nuts. Tighten the nuts to 89 inch lbs. (10 Nm). Connect the window ...
...Install new window regulator electric drive arm plastic guides into front door window channel bracket and bend tab back to 90 degrees. Use care not to break tab; if tab is cracked or broken, replace ...
...the screws that secure the power window motor to the window regulator. Tighten the screws to 9 Nm (80 in. lbs.). 3. Install the window regulator onto the door. 4. Reconnect the battery negative
...Install the door window regulator bolts and tighten to 89 inch lbs. (10 Nm). Install new pull rivets. Install the upper left rivet first, followed by the lower right rivet. Install the door window ...
...plate. Connect the electrical connector to the window regulator motor. For rear window, install the rear speaker. Install the water deflector. Install the trim panel. Hope helps (remember rated
...window regulator To install: NOTE By removing window regulator motor, gearing shifts, it is not centered. Fig. By removing window regulator motor, gearing shifts, it is not centered When installing ...
...the nut and the bolt that were used in order to secure the sector gear in position. Install the rivets in order to secure the power window motor to the window regulator. Install the window
...Install window regulator electric drive with three screws. Do not overtighten screws. Connect the window regulator electric drive harness connector. Install front door window glass. Adjust front door ...
window upward.To install: 10. Position the new window in the door. 11. While holding onto window move regulator to half up position. 12. Install the nuts. Roll the window to the full
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions