...old TPS, install the new one, and try to achieve the SAME adjustment. If you get the adjustment wrong, the engine will idle up & down. If it does, move the new TPS slightly until the idle smooths
...sensor tps de un ford thunderbird 1996 El sensor de posición del acelerador (TPS) está conectado con el eje del acelerador en el cuerpo del acelerador. Se trata de un potenciómetro con ...
TPS from the throttle body. To install: The throttle shaft end has a tang that can be fitted into the TPS two different ways. Only one of the installed positions is correct. When correctly positioned,
Question about 2001 Grand Cherokee
...TPS. To Install: The TPS is mounted to the throttle body. The throttle shaft end of throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. ...
...tps sensor, when installing new sensor you need to make sure that the arm in the throtlebody is connect to new sensor. if you look at sensor its spring loaded so make sure it goes in correctly so it ...
...installing new TPS. Started engine, still high idle, still code 22. This happened to me, it was the sensor. From the sound of your problem, it sounds like the air flow sensor (relatively cheap
Question about 1999 Cherokee
...Install TPS and retaining screws. Tighten screws to 7 Nm (60 inch lbs.) torque. Connect TPS electrical connector to TPS. Manually operate throttle (by hand) to check for any TPS binding before ...
...cant,you must replace the throttle body try a breakers yard . Throttle Position Sensor replacement in Toyota Tacoma TPS install vid The above should show you how to replace the TPS. Hope this ...
...TPS. install The throttle shaft end of throttle body slides into a socket in TPS. The TPS must be installed so that it can be rotated a few degrees. (If sensor will not rotate, install sensor with ...
Question about 2005 Grand Cherokee
...Install the TPS seal over the throttle shaft.
With the throttle valve closed, install the TPS on the throttle shaft.
Rotate it counterclockwise, to align the mounting holes.
Install the two ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions