...old TPS, install the new one, and try to achieve the SAME adjustment. If you get the adjustment wrong, the engine will idle up & down. If it does, move the new TPS slightly until the idle smooths
INSTALL THE TPS DONT JUST LINE UP THE HOLE S FOR THE SCREWS YOU HAVE TO SEE WHICH WAY THE INSIDE OF THE TPS TURNS THEN INSTALL THE TPS A 1/8 OF A TURN OR SO THAT WHEN IT SLIDE ON THE TROTTLE SHAFT YOU
en donde va el sensor tps de un ford thunderbird 1996 El sensor de posición del acelerador (TPS) está conectado con el eje del acelerador en el cuerpo del acelerador. Se trata de un potenci&
TPS from the throttle body. To install: The throttle shaft end has a tang that can be fitted into the TPS two different ways. Only one of the installed positions is correct. When correctly positioned,
Question about 2001 Grand Cherokee
...TPS. To Install: The TPS is mounted to the throttle body. The throttle shaft end of throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. ...
...key in the thing. Don't know what its called but yea its next to the gear shiffing thing what the problem is it because the tps not install right or its something eles. automatic or manual ...
Question about 1999 Cherokee
...Install TPS and retaining screws. Tighten screws to 7 Nm (60 inch lbs.) torque. Connect TPS electrical connector to TPS. Manually operate throttle (by hand) to check for any TPS binding before ...
Question about 1999 Cherokee
...the check engine turn back on. What do i have to do? check codes again. if same codes, check installation of tps. may be another problem along that circuit if new tps good and installed ...
...TPS. install The throttle shaft end of throttle body slides into a socket in TPS. The TPS must be installed so that it can be rotated a few degrees. (If sensor will not rotate, install sensor with ...
Question about 2005 Grand Cherokee
...Install the TPS seal over the throttle shaft.
With the throttle valve closed, install the TPS on the throttle shaft.
Rotate it counterclockwise, to align the mounting holes.
Install the two ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions