...fixed by having the computor flashed at dealer? your truely, desperate mechanic. I'm sure you have installed a fuel pressure gauge and monitored the fuel pressure while the problem is ...
...intake manifold have to be removed? No i will post the procedure below. 3.4L REMOVAL OF CAM SENSOR 1. Turn OFF the ignition. 2. Remove the serpentine drive belt. 3. Disconnect the sensor electrical ...
...intake manifold bolts. Remove the thermostat housing outlet and thermostat Clean the mating surfaces. To install: Install the thermostat and housing outlet. Install the thermostat housing bolts. ...
...intake manifold. Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm). Install the air cleaner assembly. Connect the surge tank line to thermostat housing. Refill the cooling system. ...
...Install the intake gasket. Install the pushrods and rocker arms. Raise and support the vehicle. Install the catalytic converter and dipstick tube and indicator if removed. Lower the vehicle. Install ...
...install the exhaust manifold. Fill the cooling system. Connect the battery ground cable. 2.4L Engine To Remove: Water pump 2.4L Disconnect the negative battery cable Drain the engine coolant. Remove ...
...intake duct. Refill the cooling system. Install the fuel injector sight shield. 4.0L Engine To Remove: Before servicing the vehicle, refer to the precautions in the beginning of this section. Relieve ...
...intake manifold bolts. Remove the thermostat housing outlet and thermostat. To Install: Install the thermostat and housing outlet. Install the thermostat housing bolts. Tighten the thermostat housing ...
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
830 Questions