Questions & Answers for: GMC Jimmy how to install a intake manifold

Question about 1995 Jimmy

6 Answers

intake manifold. Check both the presure and return fuel lines under the manifold. More than likely they have rubbed together creating a fuel leak. To see if it is the EGR Vallve remove it clean it out

Ad

...intake manifold gasket go to a self-serve car wash and hit the bottom of the engine with a water jet to clean it off. then after driving the truck, stop the engine and get underneath and look for the ...

Ad

...arms and push rods, remove the intake manifold, remove the water pump and crank balancer and then the timing chain cover, remove the timing chain, using a long bolt carefully remove the

...intake manifold and install the housing while it is still wet. Refill the radiator to approximately 21/2 inch below the filler neck. If the thermostat is equipped with a pin hole, be sure to install ...

...intake manifold, still backfiring. it has 65 psi fuel pressure. this whole problem started after wife drove car it quit and had to tow home. distribitor is tight. i have not checked with a timing ...

...to 35 ft-lbs, in proper sequence. STEP4 Install the distributor. STEP5 Install the upper intake manifold. The remaining installation procedures are basically the reverse of removal. Have a nice

Question about 2000 Jimmy

1 Answer

...install it myself I'm assuming you have the 4.3 liter engine in it. It should be in the front of your intake manifold. Follow you upper radiator hose from your radiator to the intake manifold. ...

intake manifold & gaskets on a Just replace lower intake manifold & gaskets on a 99 gmc jimmy. hooked everything up and the car idles between 1500 & 2000 rpms. Also i had forgot to hook up the

Question about 1998 Jimmy

1 Answer

install the tester and pump up the cooling system and then you watch for where the coolant is coming from. Look closely at your water pump, intake manifold gasket, radiator, heater hose coupler on the

Question about 1987 Jimmy

1 Answer

...my intake manifold gaskets. It was hard to install the intake and gasket moved just enough and I had a coolant leak. Removed manifold and installed new gaskets and problem was solved. Good

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

1998 GMC Jimmy
1998 GMC Jimmy

1,127 Questions

1999 GMC Jimmy
1999 GMC Jimmy

1,104 Questions

2001 GMC Jimmy
2001 GMC Jimmy

838 Questions

Manuals & User Guides

Loading...