Questions & Answers for: Chevrolet Malibu how to install a intake manifold

intake manifold vacuum hose. === clean throttle plate with Berryman carburator cleaner SEE sample picture HERE === Also remove carbon built up behind the EGR valve and the EGR passage tube. === Vacuum

...install a fuel line on rear fuel rail (back of engine) I just finished replacing the Lower Intake Manifold gasket (The original was plastic but they leak so I put in a new one). I tested for coolant ...

...intake manifold leak (a common thing with the 3.1, 3.4, and the 3.8) I almost sold the car. cost me a total of $650.00 to have it fixed, which in some cases will be reimbersed by GM , for the lower ...

Install the intake manifold cover, if required. Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system Fig. 3

intake manifold vacuum hose. === clean throttle plate with Berryman carburator cleaner SEE sample picture HERE === Also remove carbon built up behind the EGR valve and the EGR passage tube. === Vacuum

...intake manifold gaskets, verified no CO2 in the coolant to indicate a head gasket fault, and replaced the coolant temp sensor. It's over-heating and boiling out of the coolant reservoir. It's only ...

...install the intake manifold plenum. Connect the negative battery cable. Turn the ignition to the ON position for two seconds, then turn it to the OFF position for ten seconds. Turn again to the ON ...

...Install lower the intake manifold attaching bolts. Apply sealant or equivalent thread locking compound to the threads of bolts. Tighten the vertical bolts first, then the diagonal bolts to 115 inch ...

...intake manifold. Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm) Install the air cleaner assembly. Connect the surge tank line to thermostat housing. Refill the cooling system. ...

...intake manifold, if the RPM's increase that's where your leak is going to be, another thing, did you gap the plugs properly when you installed them, and also check under the distributor cap,, ...