Question about 2003 Impala
...intake manifold to replace the firewall side plugs. How difficult a job is this? Will it require more tools, such as a torque wrench and/or new manifold gaskets? I have a 2003 chevy Impala and it's ...
...Install the EGR valve with a new gasket to the intake manifold. NOTE: Refer to Fastener Notice in Service Precautions. Reinstall the bolts through the EGR valve into the intake manifold. Tighten ...
...intake manifold. I had the same problem and found out there was a leak there and had to replace the gasket, which is very common for this vehicle. may have blown head gasket need to a compression ...
...intake manifold. Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm) Install the air cleaner assembly. Connect the surge tank line to thermostat housing. Refill the cooling system. ...
...intake manifold. Apply some rtv to the bolt threads before reattaching housing. Tighten bolts snugly but do not over tighten. Tighten exhaust crossover and reattach the heat shield. Install throttle ...
intake manifold, valve rockers and push rods. you will need to install new head bolts when you reassemble. Once the heads are off they need to be checked for "flatness". A machine shop can do this for
intake manifold. To Install: Apply clean engine oil to the MAP sensor inlet tube. Install the MAP sensor on the intake manifold. Connect the MAP sensor harness connector. Install the engine cover. ---
...intake manifold and manifold gasket. Disconnect the throttle body inlet duct from the engine. Twist off the radiator cap to allow draining of the coolant to flow more smoothly. Place an empty ...
...install a vacuum gauge on a intake manifold port normal readings should be 16 inches or more at idle then drive car as you accelerate to a higher speed this should drop slightly once at full throttle ...
Question about 2002 Impala
...intake manifold. the rail is pushed down but i can still see the stainless steel above the bottom o-ring wipe off all o-rings well and apply vasoline to them all to ease install. I push down on rails ...
Usually answered in minutes!
2,177 Questions
1,746 Questions
1,386 Questions
1,400 Questions
1,452 Questions