INSTALL A REMAN. ECM. SAME ****. I TOOK THE ECM AND GET IT INSTALLED ONTO ANOTHER 97 ASTRO THAT IS WAS RUNNING RIGHT. GUESS WHAT?, THAT OTHER VAN RUNS PERFECT. SWAPPED THE ECM BACK TO THE ORIGINAL VAN
intake manifold. -Using the extension helps, since it's a tight area to work in. Makes the removal and installation so much easier. -Be careful not to ruin the gasket. You can replace it but you don't
intake manifold. -Using the extension helps, since it's a tight area to work in. Makes the removal and installation so much easier. -Be careful not to ruin the gasket. You can replace it but you don't
...Install fuel meter body assembly into the intake manifold. Torque the fuel meter bracket retainer bolts to 88 inch. lbs. (10 Nm). CAUTION To reduce the risk of fire or injury ensure that the poppet ...
...clean drive Not to bad, just follow upper radiator hose to intake manifold. Remove t-stat housing. T-stat will have rubber ring on it. Just replace with new t-stat and rubber gasket. and there you
...Install the lower intake manifold. Tighten the bolts in sequence and in 3 steps, as follows: Step 1: 26 inch lbs. (3 Nm). Step 2: 106 inch lbs. (12 Nm). Step 3: 133 inch. lbs. (15 Nm). Install or ...
...intake manifold: This procedure is for the CSFI system as the CMFI system uses an integral fuel pressure regulator. The CSFI uses a replacable unit mounted on the CSFI assembly. REMOVAL & ...
Usually answered in minutes!
481 Questions
367 Questions
305 Questions
235 Questions
244 Questions