Questions & Answers for: Buick LeSabre how to install a intake manifold

...intake manifold....it seems would be impossible to replace '' very conjested where its mounted''............does the intake manifold have a push on barb for the hose?I want to cut off the small piece ...

...Install the water outlet to the intake manifold with RTV sealer. Tighten the attaching bolts to 20 ft. lbs. (27 Nm). Connect the radiator hose to the water outlet housing. If necessary, attach the ...

...Install the intake manifold, fitting the plenum duct over the intake manifold duct. Loosely install the intake manifold bolts. Intake manifold torque sequence-4.6L engine Tighten the intake manifold ...

...install magnetic block heater The "block" is the center of the engine that everything is bolted to. Looking from the top down. First thing is the Intake manifold. It is bolted to the Cylinder head or ...

...intake manifold,it has an electrical plug connector with 3 wires,just disconnect the plug some have a plastic lock clip that must be removed first it`s usually a green colour then on either side of ...

...intake manifold assy and ignition module installed after a month, the #6 cylender is miss fireing and the engine is running too rich. The machinic did alot of tests and checks but he said it is still ...

...intake manifold, an EGR valve that is allowing too much flow.If it is hard to pinpoint take some brake cleaner or starting fluid around the intake manifold and vacuum lines and see if the engine ...

manifold intake gasket, any suggest? please im so stress Take it back to who ever is guessing what the issue is and tell them to fix the intake gasket. IT was not installed correctly or torqued right.

...intake manifold gasket leaks, that can cause the sensor to read wrong. With motor running, spray starting fluid (ether) around the intake gasket sealing areas. (not into throttle body) if it revs the ...

intake manifold first, then the valve covers, make sure then the #1 piston is up to top dead center on compression stroke and the marks are lined up on the timing tab, loosen all the rocker adjustment