Questions & Answers for: Nissan how to install a intake manifold

...Intake Manifold for 3.3L Nissan Xterra 2000 Please You send Me a Torque and sequence to Intake Manifold for 3.3L Nissan Xterra 2000 Hi El Faraon, I believe that you're dealing with 12 mm bolts and ...

Ad

Question about 2004 350Z

3 Answers

...install a free flowing aftermarket air intake kit, like one from K&N corp. Hi, you can upgrade to an K&N air filter and you can also add a chip that will electronically increase you HP threw tweaking ...

Ad

...intake manifold. 5. Install the new knock sensor onto the intake manifold and tighten the mounting bolts. 6. Reconnect the electrical connector to the knock sensor. 7. Start the engine and check for ...

...Install rear main seal Bolts: 1-16 (M10) 26 ft. lbs. Bolts: 1-16 (M10) Plus 90 degrees clockwise ⑬ Step 1: 33 ft. lbs. Step 2: Plus 84-90 degrees clockwise ⑭ Intake manifold ...

Question about 1998 Maxima

1 Answer

...intake manifold, then install and tighten the mounting bolts to 15-22 ft. lbs. (20-30 Nm).Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 26-47 ft. lbs. ...

...the hose for the intake manifold (sucks in air , above the carborator) has nothing connected and I'm lost on how to figure where my car needs air and where it needs to be sealed? Could you

...install the thermostat on 2005 Nissan Altima 2.5? This is a pretty easy repair. Your vehicle has 2 thermostats. One on the driver side of motor just below the intake manifold and the other in the ...

...intake manifold. Disconnect the starter harness connectors. Remove the two starter mounting bolts, using power tools. Remove the starter. INSTALLATION To install, reverse the removal procedure. ...

...intake manifold removal and instalation 2009 nissan maxmia google one there are manuals for everything ,try auto parts store get the chiltons auto repair book for car in question ,even go online ...

you have problem in fuel system or injector please check the following. - Intake manifold cracked or loose bolts. - Main injector o-ring installed backwards - Injector Holder in some cases caused code

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2000 Nissan Maxima
2000 Nissan Maxima

1,309 Questions

1995 Nissan Maxima
1995 Nissan Maxima

1,122 Questions

2002 Nissan Altima
2002 Nissan Altima

1,306 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...