...intake manifold. Best bet is to get a new gasket before re-installing, but if you don't damage it it may still be good to reuse. No need to drain oil/coolant. It's such a pain to do the rear three ...
...to remove intake manifold and applicable parts to gain acess to spark plug coils, remove coils and remove plugs install reverse order If 4 cyl remaove cover on valve cover remove spark plug coils
...for a filter in the fuel line between the intake manifold and the firewall. You should see two clamps, with pliers remove the clamps on each side of the filter and pull filter off and install new
...Install the new intake manifold gasket and the intake manifold. Tighten the nuts and bolts to the specified torque. Install the new exhaust manifold gasket and the exhaust manifold. Tighten the ...
...Install the new intake manifold gasket and the intake manifold. Tighten the nuts and bolts to the specified torque. 10. Install the new exhaust manifold gasket and the exhaust manifold. Tighten the ...
Question about 2001 XG300
...intake manifold was completely clean and we noticed that the worm gear and worm gear sprocket are damaged. That would be the gear is missing teeth. This gear turns the six valves inside the intake ...
Question about 2002 XG350 L
...intake manifold was completely clean and we noticed that the worm gear and worm gear sprocket are damaged. That would be the gear is missing teeth. This gear turns the six valves inside the intake ...
...manifold near plenum intake duct. Remove connection careful....deep socket 12 mm.. then install new one. Top up coolant in radiator.. verify temp on dash Guage. .Hot. .. coolant fans should come on
Question about 2002 Santa Fe
...Intake And Exhaust System" in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block. Installation • Install the ...
Question about 2002 Santa Fe
...intake manifold are installed together TORQUE SPECIFICATIONS all readings in ft. lbs. Year Engine Displacement Liters (cc) Engine ID/VIN Cylinder Head Bolts Main Bearing Bolts Rod Brearing Bolts ...
Usually answered in minutes!
1,503 Questions
1,180 Questions
1,131 Questions
1,254 Questions
1,082 Questions