Questions & Answers for: GMC how to install a intake manifold

...intake manifold. Install the canister purge valve. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners ...

Ad

...install. All fuel lines have to be disconnected and needs a special tool. While you have the intake off, spray 3 or 4 cans of throttle body cleaner thru the plastic manifold. The parts only take ten ...

Ad

Question about 1992 Sierra K1500

1 Answer

...install intake manifold gaskets Im installing a intake manifold and need to know which way the gasket block plates face. Do the gasket block off plates go front or back The plates go to the rear. On ...

...PrecautionsInstall the knock sensors. Tighten Tighten the sensor to 20 N.m (15 lb ft) Connect the knock sensor electrical connectors. Push down on the rubber covers. Install the intake

...Install new gaskets and intake manifold on block while RTV is still wet to the touch. Use Threadlock 12345382 or equivalent to lower intake manifold bolts. Tighten lower intake manifold bolts in ...

...intake manifold and install the housing while it is still wet. Refill the radiator to approximately 21/2 inch below the filler neck. If the thermostat is equipped with a pin hole, be sure to install ...

...to 35 ft-lbs, in proper sequence. STEP4 Install the distributor. STEP5 Install the upper intake manifold. The remaining installation procedures are basically the reverse of removal. Have a nice

Question about 2000 Jimmy

1 Answer

...install it myself I'm assuming you have the 4.3 liter engine in it. It should be in the front of your intake manifold. Follow you upper radiator hose from your radiator to the intake manifold. ...

Question about 1998 Jimmy

1 Answer

install the tester and pump up the cooling system and then you watch for where the coolant is coming from. Look closely at your water pump, intake manifold gasket, radiator, heater hose coupler on the

Question about 1987 Jimmy

1 Answer

...my intake manifold gaskets. It was hard to install the intake and gasket moved just enough and I had a coolant leak. Removed manifold and installed new gaskets and problem was solved. Good

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...