...intake/exhaust is a split design(2 piece). How do you install this properly? Do I bolt it to the head, and then tighten the upper/lower manifolds together, or tighten them together and then bolt to ...
...intake manifold. To install: Install the EGR valve, along with a new gasket, on the upper intake manifold, then install and tighten the mounting bolts to 15-22 ft. lbs. (20-30 Nm) on 3.8L engines, or ...
Intake Manifold Special Tool(s)Remover/Installer, hose clamp 412-108 (T96P-18539-A) Removal Release the fuel pressure. For additional information, refer to Section 310-00.Disconnect the battery ground
...intake manifold. To install: If removed, install the EVR solenoid and mounting bracket onto the upper intake manifold. If applicable, install the EGR tube heat shield. Position the PFE/DPFE sensor on ...
...intake manifold 3.0 engine TORQUE SPECIFICATIONSDescriptionNmLb-FtLb-InEngine Air Cleaner Tube Clamps1.6-2.2-14-19Engine Control Sensor Wiring Through Bolts2.5-3.5-23-30Generator to Bracket ...
...intake manifold runner control was malfunctioning in bank one. inexpensive fix? I'll explain the part. The manifold runner is like a venetian blind. It is suppose to move to change drawing air into ...
...Intake Manifold Tightening Sequence Reverse procedure to install. Torque bolts and nuts in sequence to 14-19 ft lb. My name is Tim and I work for a company called AutoEcu1 We specialize in many ...
...Intake Manifold, install the new gaskets and bolt it back in place. My best advice to you is go to a auto parts store and buy a manual as it will tell you exactly how to do it. Well that was a ...
Question about 1989 Bronco II
...intake manifold Positive Crankcase Ventilation (PCV) Valve Removal and Installation Remove the intake manifold. For additional information, refer to Section 303-01 . Disconnect positive crankcase ...
Question about 1989 Bronco II
...install a intake manifold runner control on a ford f-150 2005 4.2 First make sure the vacuum runner control motor has vacuum at the runner control vacuum control solenoid. Attach a vacuum pump to the ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,347 Questions
2,636 Questions