Questions & Answers for: Dodge how to install a intake manifold

Question about 2005 Ram 1500

2005 Dodge 1500 code p0404 EGR valve.

...intake manifold. Install EGR tube flange bolt (1) at intake manifold. Tighten bolt. Refer to Torque Specifications. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final ...

Question about 2001 Durango

1 Answer

How hard is it to replace the MAP sensor on a 2001 dodge durango?

intake manifold. To Install: Clean MAP sensor mounting hole at intake manifold. Check MAP sensor O-ring seal for cuts or tears. Position sensor into manifold. Install MAP sensor mounting bolts (screws

Question about 1999 Ram

1 Answer

Where is the IAT sensor for a 99 5.9 diesel ?

...Intake Manifold Air Temperature (IAT) sensor is installed in the intake manifold with the sensor element extending into the air stream: This is a Negative Thermal Coefficient (NTC), meaning that as ...

Question about 2000 Durango

1 Answer

How do i replace the

...Install or connect the following: Push rods and rocker arm assemblies in their original positions. Torque to: 21 ft. lbs. (28 Nm) Intake manifold and throttle body assembly Exhaust manifolds Spark ...

Question about 1991 Colt

1 Answer

Thermostat replacement diagram

...Install the housing and pipe assembly. Torque the housing bolts to 11 ft. lbs. (14 Nm); the intake manifold nut to 14 ft. lbs. (19 Nm). Refill the system with coolant. Connect the negative battery ...

Question about 2002 Intrepid

1 Answer

Need location of 2002 intrepid

...the electrical connector from the MAP sensor. Remove bolts from sensor. Remove sensor. To install: Bolt sensor to intake. Attach electrical connector to sensor. Install the negative battery

Question about 2003 Durango

1 Answer

Replace egr valve on 2003 durango

Question about 2003 Dakota Club Cab

1 Answer

How do i get to the iat sensor on a 2003 Dodge dakota 4.7L V8

...Intake Manifold Air Temperature (IAT) sensor is installed in the intake manifold with the sensor element extending into the air stream. It sits on the left side of the engine above the Idle Air ...

Question about 2003 Dakota Club Cab

1 Answer

Knock sensor location on a 2005 dodge Durango 4.7 liter

...the intake manifold. The intake manifold must be removed to replace them. They are not identical, and must be installed in the correct position (they are tagged) so that the PCM knows which is

Question about 2003 Intrepid

1 Answer

03 Dodge Intrepid intake manifold torque specs top & bottom is for 3.5 V6

...intake manifold torque specs top & bottom is for 3.5 V6 I Need the torque specs for the top & bottom intake manifolds Lower Intake: Use a skin coat of RTV silicone on both sides of the water passage ...