...Install the intake manifold. Connect the negative battery cable. 3.5L Engine To Remove: Disconnect the negative battery cable. Remove the intake manifold. Use compressed air to clear the area around ...
...Tighten bolts to 12.5 Nm (110 inch lbs.). Install upper radiator hose. Connect the coolant recovery system hose. Install upper intake manifold. Fill cooling system. see thermostat mounting are ...
...intake manifold is that a gasket leak and how much for part approx.? From what your describing it sounds like a blown intake gasket, the gasket itself costs under $30 if you are doing this yourself. ...
...intake manifold bolts and manifold12. Remove old gaskets, Clean gasket surfaces, and install new gaskets.13. Reverse steps to reinstall manifold you must remember that the gaskets you are ...
Question about 2004 Pacifica
...Install upper intake manifold and hand start all attaching bolts.
5)Tighten bolts gradually starting in the center working outward until a torque of 12 Nm (105 inch lbs.) is obtained.
6)Install ...
Question about 2004 Pacifica
...intake manifold on Chrysler 300C 5.7 hemi? Blew a valve seat in old engine and destroyed the engine and intake manifold. Replaced engine with a completely rebuilt 5.7 hemi and added a new intake ...
Question about 2004 Pacifica
...Install Intake Manifold, refer to the Engine section. Install the engine cover or throttle control shield if equipped. Install the negative battery cable. Install the air cleaner lid, connect the ...
Question about 2004 Pacifica
...Install Intake Manifold, refer to the Engine section. Install the engine cover or throttle control shield if equipped. Install the negative battery cable. Install the air cleaner lid, connect the ...
Question about 2006 Pacifica
...replacing plugs and re installing ntake manifold when I start car it is very noisy and 2500rpm idle Sounds like the intake manifold isn't sealed correctly, leading to higher mixture fuel, air
...intake manifold bolt. Install and tighten bolts to 12 N·m (105 in. lbs.) using torque sequence. Here is the torque sequence for the 3.8L upper intake plenum: 6 2 4 5 1 3 Please note that this ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions
