...pinion gear. Sounds as if there is a shim missing, which will cause the pinion gear to hit the ring gear, causing noise, and considerable damage to both. Make sure the gears are all good. Another ...
...install: Apply a light coating of gear lubricant on the lip of pinion seal. Install seal with Installer C-3972-A and Handle C-4171. Install pinion flange onto the pinion with Installer C-3718 and ...
...install: Apply a light coating of gear lubricant on the lip of pinion seal. Install seal with Installer C-3972-A and Handle C-4171. Install pinion flange onto the pinion with Installer C-3718 and ...
...Install an Nm (inch/pound) torque wrench on the nut and record the torque necessary to maintain rotation of the drive pinion gear through several revolutions. CAUTION: After removing the nut, discard ...
Question about 2004 Mustang
...gear and pinion in my 1968 Camaro with a 12 bold rear end. It has 373 ratio now but the rear end code said it had 410 ratio. I want to change the ratio to 410. You can change the ratio back to 4.10. ...
...gear lube. Install oil seal using appropriate seal installer. Drive oil seal into axle housing until oil seal installer contacts axle housing. 2. Install pinion flange on pinion with reference mark ...
pinion gear(this is called in mecanic's word pre-load of your pinion gear)first witch is achievable by inserting shim washers and tightennig the pinion gear bolt. Then and only then you can adjust the
remove/install the pumpkin with its bearings in place. If you're replacing the pinion gear, you'll need to take some painfully exact measurements or you'll NEVER get the ring/pinion clearances correct
Question about 1998 Ram 1500 4WD
...gear and install the air cleaner. Install the intermediate shaft seal and the intermediate shaft-to-stub shaft pinch bolt. 2.2L Engine Disconnect the negative battery cable. Install an engine support ...
...gear mesh alignment when reassembling. Carefully remove the pinion flange from the pinion shaft. Use a bearing puller tool to remove the old pinion bearing from the pinion housing. Install a new ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions