...pinion gear. Sounds as if there is a shim missing, which will cause the pinion gear to hit the ring gear, causing noise, and considerable damage to both. Make sure the gears are all good. Another ...
...install: Apply a light coating of gear lubricant on the lip of pinion seal. Install seal with Installer C-3972-A and Handle C-4171. Install pinion flange onto the pinion with Installer C-3718 and ...
...install: Apply a light coating of gear lubricant on the lip of pinion seal. Install seal with Installer C-3972-A and Handle C-4171. Install pinion flange onto the pinion with Installer C-3718 and ...
...gear lube. Install oil seal using appropriate seal installer. Drive oil seal into axle housing until oil seal installer contacts axle housing. 2. Install pinion flange on pinion with reference mark ...
...Install gear shift cable on cable mounting bracket of transaxle and securely tighten bolt. Lower the vehicle. Connect the negative battery cable. Refill the pump reservoir to the correct lever with ...
...this you will need to tighten the nut in small increments then use the torque to rotate wrench to turn the pinion without the carrier/ ring gear installed. Repeat until desired torque is
Question about 1996 Intrepid
...seal on my 2004 dodge ram 1500 4x4 i found that the pinion nut had loosend i replaced the seal and installed a new pinion nut but couldnt really find an accurate torque spec for it. i found anywhere ...
pinion gear(this is called in mecanic's word pre-load of your pinion gear)first witch is achievable by inserting shim washers and tightennig the pinion gear bolt. Then and only then you can adjust the
Question about 2004 Ram 1500
pinion. I doubt they shaved to install new ones on. Typically those bearings are a light press-on fit. At any rate, they aren't charging you for the second repair? Sometimes rear ends can be a pain to
Question about 2001 Ram 1500 Truck 2WD
...install the ring gear carrier and check contact pattern and backlash. That said, you probably will be alright if you re-torque the pinion nut to spec plus a hair. Look it up in a manual. EXAMPLE: if ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions