...equivalent meeting Ford specification ESA-M1C75-B. Using the special tools, install the wheel bearing oil seal. Install the axle shaft. For additional information, refer to Axle Shaft in this
Question about 2004 Crown Victoria
...Install axle housing cover and tighten retaining bolts to 28-38 Nm (38-52 lb-ft). Add Motorcraft Rear Axle Lubricant XY-90-QL or KL (ESP-M2C154-A) or equivalent until it is 6-14mm (1/4-9/16 inch) ...
22833. Install the deflector (28). Install the axle shaft (output shaft) (19). Carefully tap the axle shaft (output shaft) (19) into place with a soft mallet. Install the differential carrier assembly
...INSTALL THE AXLE INTO THE AXLE TUBE.POSITION AND ALIGN THE SEAL RETAINER AND BRAKE SUPPORT PLATE AND INSTALL REPLACEMENT ATTACHING NUTS.TIGHTEN NUTS TO 32 FT LBS.INSTALL BRAKE ASSEMBLY WHEELS LOWER ...
...axle, install the slide hammer and adapter behind the bearing and pull out the bearing and seal together. If replacing the rear axle shaft seal and the bearing on the 9.75 inch axle, install the J ...
...Install the axle housing cover and fill the rear axle housing (4010) with 2.4 liters (5.5 pints) of specified lubricant; refer to Axle Housing Cover in this section. WARNING: Always remove any ...
...when you can install it by hand. Then install axle, tighten axle nut, and install ball joint back into control arm. And tighten. Don't forget to put cotter pin in and check the transmission
If you bought a new axle and seal, it shouldn't leak. Unless they nicked the seal putting the axle. When using a used axle, it needs the rust sanded off before installing. That rust will eat up a seal
Question about 2006 Liberty Renegade
...Install axle shaft through seal, bearing and engage into side gear splines. Install C-lock in axle shaft end, then push axle shaft outward to seat C-lock in side gear. Install pinion mate shaft into ...
Question about 2006 Liberty Renegade
...getting nicked by the plines of the axle. About the only solution is to remove the axle shaft and install a new seal. It's probably not the thing you wanted to hear, but there it is. Hope this
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions