Questions & Answers for: Ford Five Hundred input turbine sensor

Question about 2005 Five Hundred

1 Answer

Backup sensors not working I have a 2005 Ford Five-Hundred with backup sensors. A few weeks ago the system started shutting off automatically although it would still work sometimes. How do I find out ...

Ad

Question about 2005 Five Hundred

2 Answers

...UP WHAT DOES THAT CODE MEAN The P0715 tells you TCM detected a loss of TSS signal during operation. Insufficient input from the turbine shaft speed sensor. P0715....Input/Turbine Speed Sensor ...

Ad

Question about 2005 Five Hundred

1 Answer

I have a 2005 Ford Five Hundred has a CODE P2195 and only run at idle speed can you recommend a fix. 02 sensor is stuck lean ( bank 1 sensor 1 )--bank 1 is the side for # 1 cylinder. oxygen sensors ...

Question about 2007 Five Hundred Limited Sedan

3 Answers

how do i take the wheel sensors off of a 2007 ford five hundred? Hi, if you are referring to the tire pressure sensors they are actually the valve stems that you put air into the tire with, the sensor

My abs in traction light came on after I changed the wheel bearings Check out ford dealer...They can help probably for free. It's sounds pretty simple. They'll diagnose it quick. It sounds ...

...input TR sensor signal is below threshold of 0.127 volts, sensor/circuit electrical malfunction TR sensor indicates a stuck position (D-3rd gear), no adaptive or self learning strategy. Install a new ...

Cranks up, stalls, rough idle, no throttle responce No codes, Disconnect Mass Air flow goes into failsafe, Idles rough but has throttle responce. possibly the TPS....also check it for vaccum leaks Can

Question about 2005 Five Hundred

1 Answer

where is the speed sensor located? 2005-2007 Ford Five Hundred Speed Sensor - JC Whitney www.jcwhitney.com/2005...ford-five-hundred/...speed-sensor...speed-se... Shop for a 2005-2007 Ford Five Hundred

Question about 2006 Five Hundred

1 Answer

...sensor is an input to the powertrain control module (PCM) and is used to determine the torque demand. There are 3 pedal position signals in the sensor. Signal 1, APPS1, has a negative slope ...

...Input A Circuit Range/Performance Go To Pinpoint Test C . P0581 Cruise Control Multifunction Circuit High Go To Pinpoint Test C . P0720 Output Speed Sensor Circuit REFER to the Powertrain ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...