Questions & Answers for: Jeep input sync

Question about 2003 Grand Cherokee

2 Answers

When cold it will run ok, but after it warms up it starts missing until it dies. I let cool off for a while and it will start again. I replace the spark plugs, crank sensor and the coil pack. When it ...

Ad

Question about 1994 Grand Cherokee

2 Answers

1996 jeep grand cherokee limited. engine is shutting off/stalling out while driving/idleing. there are no check engine or check gauges light appearing. coolant sensor is now being displayed sometimes ...

Ad

Question about 2000 Grand Cherokee

1 Answer

where is the camshaft position senor on a 2000 jeep grand cherokee 4 liter 4.0L The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft ...

Question about 2000 Grand Cherokee

1 Answer

where is the camshaft position sensor located on a 06 jeep grand cherokee limited 4.7 l automatic ? ... also the crank position sensor The CMP sensor engine contains a hall effect device called a sync

...input indicates rich air/fuel ratio condition during engine operation. 53* PCM internal fault condition detected. 54* No fuel sync (camshaft signal) detected during engine cranking. 55* Completion of ...

...input indicates RICH air/fuel ratio condition during engine operation. Code 53-Internal controller failure-internal engine controller fault condition detected during self test. Code 54-Camshaft or ...

Question about 1999 Grand Cherokee

1 Answer

...sync signal generator.When the cam gear is rotating, the sensor will detect the notches. Input voltage from the sensor to the PCM will then switch from a low (approximately 0.3 volts) to a high ...

My 1998 Cherokee with 4.0 will run but cannot get cam/ crank sync. My 4.0 jeep Cherokee will run , but stutters. The motor has 150k on it. I Replaced the crank position sensor , and the distributor. ...

i need. the. location. of. the input speed sensor on. jeep liberty 02 Looking for how. To. Replace and. Locate where to find input. Speed. Sensor changed. My crankcase sensor. codes. Erased but now. A

2008 Jeep Commander Input/Turbine Speed Sensor code P0717. I need to know where it is located and possibly the exact part name as AutoZone has no clue. Question editerd for clarity. Question moved to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...