Questions & Answers for: IBM ThinkVision input signal range change settings

...range frequency. The question that remain though it is that I can't turn the monitor on or off and that even when I change this monitor to an other computer with a different rate frequency. The ...

input signal out of range". I have not been able to fix this problem. Do you have any ideas? Thanks, Tammy Lowery email [email protected] Hi! Tammy, It's seems your new pc resolution settings, set

...input signal. Check your cables between the computer and monitor. Replace them if need. Also check the pins and make sure that none are bent or disfigured. Try a replacment monitor from a family ...

my monitor wont install onto my hard drive what can i do and it ismaking everything huge 1) You need to set your PC video out to be native resolution of your IBM monitor, which is 1280×1024 @60Hz

input signal out of range''... (More) (More) I just purchased a IBM thinkvision monitor, and a box the at reads'' input signal out of range'' keeps bouncing around my screen. How do I get rid of it. I

Im trying to set mty screen resolution without disk so i dont have the right software for my ibm L170 think vision monitior Native resolution for this monitor is 1280 x 1024 @60Hz. Verify that your PC

...org/wiki/Capacitor_plague Capacitors kit: http://lcdalternatives.auctivacommerce.com/ he can make you a set of caps for you. http://www.badcaps.net ibm input signal out of range how can i fix it ...

...signal is out of the display range, but I'm sure this is not the problem (signal is fine and this flashing cycle is longer than .5 seconds). The monitor worked fine when the computer was disconnected ...

...signal cable. Try moving the cable around steadily and see if the color suddenly goes back to normal or changes to a yellow hue. If this is the case and you are able to remove both ends of the cable ...

...out of range Change your resolution to something lower. Sounds like your video card is overdriving your monitor. Reset your resolution to 800 x 600. If that works ok, you can push it a little