...input cables. Are the lights still on? It is possible that you can have a ground loop that is putting signals in that causes clipping. Another source is if you have a microphone that may be ...
...hear a faint pop? Next plug a LOW impedance device OR even an instrument cable into the power amp "input" jack. Do this with the power off then warm amp up. Now, change the state of the clean OD.
Question about PV8 Mixer
Im trying to choose my inputs: (under preferences, Device) begin input1 and end input should be 8, but it only shows 2. Assuming I chose my ASIO4all driver that indownloaded. I can also chose ...
Question about Xr 8600 8 Channel Powered Mixer
...device and adjust the devices out put as high as it will go with out distorting the channel input. Then adjust the amp's channel and main output as you would normally to get the final volume you
...that require a small amount of power to operate. It is important to note that the XR-600B have XLR inputs which are typically used for condenser microphones that require phantom power but it does
Usually answered in minutes!
85 Questions
60 Questions
39 Questions
19 Questions
