Questions & Answers for: how to get to the input channel

...input channel @ that time. turn off the t.v and wait until the alarm turns the t.v on. go in to menu, list and ladel and add the input 1 or 2 to the channel list so when you flip though the channels ...

...channel or input is locked. 3. Press the button labeled MENU. The screen will show the main TV menu. 4. Press the #5 button (channel lock option). The screen will change to show the channel lock ...

...input to TV,you should be under either channel 3 or 4 and be sure either channel had been saved under memory.In order to change channels,you will need to change it from your directv box. JUST LIKE a ...

...Channel A input goes to the Channel A output jacks, and the Channel B input goes to the Channel B output jacks. ? PARALLEL mode The Channel A input signal is output through both the Channel A and ...

...input for both channel you can go and reverse output cables of the speakers if the problem transfer to good channel change speaker cable-if you did not have input indication in the bad channel try to ...

...channel buttons, the input is changed instead. I can still change the input through the menu route, and I can still change the channel by typing in the channel number and pressing enter (eg. number 3 ...

...input channel manually Cant get a remote to work on my toshiba television and subsequently cant set it to the input channel manually. if you go to channel 2 then channel down the channels between it ...

...input channels - Channel 1 and Channel 2. Should I buy a twin female RCA (red and white) connector so that I input both outputs into Channel 1 of the amp? Or should I buy a single female RCA to TRS ...

channel on a vizio tv? If you are using an Antenna, Coaxial cable from the wall or a cable/satellite box connected to the TV with a coaxial cable, you will need to do the following steps: 1. Press the

...channel scan using the coaxial input: Press the INPUT button on your remote to view your current input source. The TV (coaxial cable) input must be selected. This may appear as “TV,” “ANT,” or the ...