...LIGHT TO FUEL INJECTOR ELECTRICAL CONNECTOR. CRANK THE ENGINE WATCH THE NOID TEST LIGHT SHOULD BE BLINKING WHILE ENGINE TURN OVER.IF TEST NOID LIGHT STEADY PCM FAULTY NOT FIRING THE FUEL INJECTOR.IF ...
...light, and probe the injector connector with key ON. If your injector drive circuit is working, one of the terminals on the injector connector should have a steady light. Now check the ...
...injector noid light should blink when cranking the engine.if light steady pcm not firing 2 fuel injector,if noid light dont light up.there is a open in the wiring connector 2 fuel ...
Question about 2005 G6
...light probe on the injector wire that did not light the test light. Now have a helper crank the engine over-you should have a blinking light on this ground circuit. If no light, or light is not ...
...light into the injector connector and crank the engine over. If the light is blinking, circuit is good. If no light, the circuit has a problem, either on the drive side or the ground side. Here's a ...
...light shows the injector circuit is working, your fuel pressure may be too low for fuel to go through the injectors. New pump and filter I see, but fuel pressure should still be checked. If it proves ...
Question about 2005 G6
injector circuit with a test light. Here's how: Turn key to on, not start. Ground the lead of a test light to a ground source, pull the electrical connector off an injector. There will be a power wire
...light and probe the injector connector. With key on, one terminal should be hot-the drive circuit. Now move the test light lead to the POSITIVE battery post, and stick the test light probe into the ...
Question about 1988 K1500
light and probe injector connector's red wire on injector 1, and the white wire on injector 2-both should be hot with key on. This may be why the noid light didn't blink. The noid light must have this
...light. If the injector circuit ground is good, the test light will now be blinking. (You are putting voltage into the ground wire to the computer, to check if it is properly grounding the circuit. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions