Questions & Answers for: Horizon incline motor

...quit working. All of the lights and bells and whistles all work but the belt doesnt move and the incline doesnt move. Ive only had it for about 2 years. It was working fine before I moved it

...incline perodicly gets stuck at full12 degrees and won't respond 1)signal false coming console or display board2) main motor controller is faulty.3)Pot attached of the elevation motor ,need ...

do treadmills need calibrating Some do mostly for incline motor

...Found a solid metal forlike piece when I moved it. you should remove the motor cover and inspect to see if you can locate where is came from. check the incline ...

incline motor. Called tech support they claim either motor control board or incline motor needs replaced. It wasn't either. Not sure how it happened but the incline motor was not adjusted correctly to

...motor to tell the console where the elevation is in it's range from zero to full incline. I have seen 74ACT02 IC's fail on the Horizon upper boards which is a buffer for these elevation signals, and ...

incline motor needs to be adjusted back into range. If all wire connections look ok, the incline motor will need to be adjusted. Turn the power OFF, wait 5-seconds and turn back ON. Get into test mode

...incline motor issue. The motor itself seems OK, as I can operate it when 230V is applied. I have 220V on the lower board between the black/white and the red/white which would suggest that the voltage ...

incline motor replaced, still won't go down Replaced my incline motor due to the gear shaft being stripped and spinning in place. The new motor works great but now it will only go up, not back down. I

...incline works. We looked through a troubleshooting guide and were looking at the lower board indicator lights and the only light that doesn't like up is indicator light 3. Do we need to replace the ...