...seal from the impeller and clean it thoroughly as well. Apply a thin coat of lube to the seal plate and impeller where the new seal will go. Remove the new PS1000 shaft seal from the box (being ...
Question about Pool Pump Motor 1HP Square Flange Swimming Pool Pump Energy Efficient motor
...seal plate and impeller and diffuser can all be pulled back away from the pump. You need to remove the diffuser (plastic housing that goes around the impeller) usually by a series of 3 to 6 small ...
Question about Letro Booster Pump IMPELLER LA02L
...impeller and seal. Sounds like maybe your motor bearing are going bad, or have already seized up. When you say "rubber seal" are you referring to the rubber portion of the shaft seal? Either way, to ...
Question about 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame
...seal plate, and impeller all the way out and work on it. To get to the impeller, you need to remove the diffuser (plastic housing that goes around the impeller) usually by a series of 3 to 6 small ...
Question about ABOVEGROUND POOL PUMP - 1.5HP -
...seal plate, and impeller all the way out and work on it. To get to the impeller, you need to remove the diffuser (plastic housing that goes around the impeller) usually by a series of 3 to 6 small ...
Question about 1hp Power Flo Matrix Above Ground Pool Pump # Sp1592
...seal... To remove the impeller you need to lock the motor and unscrew impeller. Depending on the motor, you remove a cap in the middle of the tailpiece and hold with a wrench, or remove a cap that ...
Question about 011515 WhisperFlo FullRated Energy Efficient Pump 2Horsepower 208230Volt
...seal from the impeller and clean it thoroughly as well. 8) Apply a thin coat of lube (I prefer Magic Lube or Lube Tube) to the seal plate and impeller where the new seal will go. 9) Remove the new ...
...tank is full. Initially suspected impeller shaft as it was rusty. u have put the impeller seals in the wrong way round .they must face each other .sidecover seal faces out waterpump seal faces ...
...impeller, internal seals, and suction side seal. I need to know the specific order of seals, torque of impeller and install direction of the suction-side seal. I seems that when I re-assembleld the ...
...seal... To remove the impeller you need to lock the motor and unscrew impeller. Depending on the motor, you remove a cap in the middle of the tailpiece and hold with a wrench, or remove a cap that ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions