Questions & Answers for: GMC Safari ignition switch wiring

ignition switch or a relay is bad.(on stick vehicles add clutch switch) You can jump starter across large & small terminals and this will generally get it started. Do this with key "on" and vehicle in

ignition switch. Hi. I've put together a guide that will help you with the replacement of this ignition switch. Step1 Disconnect the negative battery cable from the terminal on the battery. Remove the

...ignition switch (disengage your airbag deploy circuits first if you remove it). You should only have juice going to the start circuit when the key is turned against the spring. Anything else is a ...

ignition switch. first you should check for 12V at the starter post w/ the smaller wire on it as the key is held in "start" position. if no, then you should probe the supply wire @ the ignition switch

...IGNITION SWITCH,YOU SHOULD HEAR FUEL PUMP TURN ON FOR 3 SECONDS THEN TURN OFF.IF YOU TURN IGNITION KEY HEAR NO FUEL PUMP OPERATION MAKE YOU INSTALL NEW FUEL PUMP WIRE HARNESS.IF ALL IS GOOD ECM NEED ...

...ignition switch and pin 30 at the starter enable relay .When you turn the key to the start position it sends B+ voltage to #8 crank fuse , located in the I/P fuse box ,from there it goes to the park ...

...ignition key in your Safari to the "Run" position, but do not crank the vehicle. Test the switch to ensure the turn signals are working correctly. Test the windshield wipers as well as the dimmer ...

...ignition switch down on the column is out of adjustment. If you have a tilt column try moving up and down all the way to see if it will start if it does your switch is not adjusted correctly or you ...

...ignition switch (no need to start your car) find the wire that has current (test light will light up). Then depress that pedal and you should have current at both terminals. If not, you probably have ...

ignition switch sol are good batteries are new If I see your problem correctly. The engine starts but won't run but it runs with a remote control. If this is your problem then I will check with a test