Questions & Answers for: Ford Explorer ignition switch wiring

Question about 1997 Explorer AWD

1 Answer

...ignition switch to take it in...we tried a door lock but they said it wouldnt work for the ignition...is there any way we can locate the numbers needed for the locksmith? thank you. vin # is ...

Ad

...ignition switch in my 1992 explorer hi, Remove the steering column cover. There should be four screws. This will give you access to the column and the switch located behind the ignition lock ...

Ad

...ignition switch on my 2001 ford explorer and now my car won't start what steps do i take in replacing the ignition if you are sure all wires are installed correctly check fuses... also you would have ...

Question about 1998 Explorer

1 Answer

but also a little wire from the ignition switch. If you dont hear a click then either the ignition switch is bad or the solenoid is bad. Or perhaps the contact from the ignition at the solenoid is bad

Question about 1998 Explorer

1 Answer

ignition switch. Not the Ignition tumbler where the key goes in but, the actual Electrical portion of the Switch. Because you have not listed the exact year and model I will tell you that the ignition

Question about 1998 Explorer

2 Answers

...ignition switch, neutral safety switch and battery. battery cables are clean and solid. I can start the Explorer by jumping across the solenoid. Once it starts it run's fine. No check engine light. I ...

...Ignition switch is in the RUN position. It should start. Be sure to have the vehicle in Park. There are some Interlocks in the gearshift and Brake pedal that prevent when certain things happen. When ...

Question about 2004 Explorer

1 Answer

...ignition switch and the coil pack, And everything else to do with the ignition and nothing,...it is starting but i cannot get the spark. Check your underdash wiring. At times wires can come lose and ...

...ignition switch turned on. Right now it is working. What was it that I did to make this work again? There is an Interlock system that connects the Brake pedal switch, trans shifter, and Ignition key. ...

ignition switch, or a wiring fault elsewhere has bypassed the accessory switch. In particular, if you have had an aftermarket radio or remote starter installed, there may be an error in the wiring. or

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

Manuals & User Guides

Loading...