Questions & Answers for: Polaris ignition switch wiring

...ignition switch put new one in and still won't start when you turn on the switch key fuel pump pumps up you can hear it do that. No headlights nothing else other than fuel pump humm You can take ...

...ignition switch on 2009 polaris 330 trail boss wireing identification to starting switch install the new one in the reverse order that you take out the old one. if you can't figure that much out then ...

...ignition switch and the 'Engine STOP/START switch (on the left handlebar) are both OFF, and has + (positive) battery voltage, when the ignition switch and 'Engine STOP/START switch are both ON, with ...

of the carb to see if the solenoid valve is connected to the wire harness. You should be able to hear it click if it's working. Make sure the ignition switch stops power to it when you stop the engine

...ignition switch. I'm not a big atv mechanic, but I think car knowledge will transfer over in this case. There should be a large and a small wire going to the starter. The large wire carries the power ...

...it. No lights on dash either. I traced wires and all are good. Any ideas Need to test to see if power is being sent from the key switch to the ignition I would think bad fuse or bad ignition ...

...key go the bike kills You have lost power to your ignition when it is in the on position check fuses or look for broken wires leading from ignition switch it could very well be in the switch it ...

no juice from the battery to ignition switch battery good turn key on nothing on 2005 polaris preditor 90. check fuse next to battery if good then connection failure or wire broken

...ignition switch clicks battery pack starts right up but is running rough and won’t remain running. Periodically blowing 20 amp fuse. Can’t find any bad connections or bare wires. Replaced ignition ...