...ignition switch my 1997 Nissan p/u started up fine. Drove it around town, stopped, turned off the engine and it started again right away. Drove it home, parked and turned off the engine then started ...
...ignition switch is weak, not providing enough voltage from the to kick the soliniod all the way to start the starter The way to check that is to hot wire the starter soliniod little wire, to battery ...
...ignition switch I hear a click int the relay under the dash and, in the computer- putting a test light to the wires on the back of the ignition switch (in the on position) all of the wires light up ...
...ignition switch or warning switch can be replaced without removing the steering lock assembly. The ignition switch is on the back of the assembly and the warning switch on the side. Disconnect the ...
...the ignition switch is on, there is full power, but ot will not start with the key in the ignition. Either bad starter relay, bad wiring between the switch and the solenoid, or a bad ignition
Question about 1999 Pathfinder
ignition switch is turned off the brake light switch will work without the key in the ignition if you push on the brake pedal, its just the way its designed. if you were to test the switch with a test
Question about 1999 Pathfinder
...ignition switch. Replace it or do away with the part that feeds 12 volts to the coil If you can get a wiring diagram for it, find the ignition wire.You could also use a 12 volt test light to find the ...
Question about 2002 Pathfinder
...ignition switch or wiring from there to the coils. With ignition on, you should have 12 volts to the coil/s. The ECM grounds it out with help from the crank sensor. If you turn the ignition switch on ...
Question about 2002 Pathfinder
...ignition switch still wont engage when jumping solenoid just bendix sound if I use ignition sw.wont do nothing help plz I was able to jump solenoid for a day now nothing .how do I fix problem? Ive re ...
Question about 2002 Pathfinder
...ignition switch. not the whole ignition, but switch which is mounted to the back of the ignition cylinder. its a round white portion of the switch that has wires coming out of it and its attached to ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions