...ignition leaving the engine OFF and wait 30 seconds . Attempt to start the engine. If the engine does not start, Refer to the A Powertrain On Board Diagnostic (OBD) System Check. YOU CAN TRY THIS IT ...
ignition stuck in run position with keys in it. I have a 1988 corvette the key is stuck in the run position. The key will not move into any other position. I had to pull a fuse to turn the engine off ...
Question about 1972 Corvette
Key stuck in ignition of 1976 chevy corvette stingray 350 auto Pretty much it. My key is stuck in the ignition. Car will start, but key will not return to locking position to allow it to be removed. ...
...key) turns the starter motor "on" while another turns the ignition "on." This way, you can get the engine turning quickly with the starter, and then flick on the ignition. It works. Mounting hardware ...
...ignition switch. Replace everything alldada.com has the disassemble ino or go buy a book. If the key does not turn to the on position then its going to be a pain. It needs to be in this position to ...
...by a locksmith to match the new key. Make sure you remove any key chain you have attached to the ignition key that is stuck and follow the removal steps for the ignition module. Should be
...ignition lock cylinder for a 1972 Corvette? The cylinder is stuck in the lock position and even with the key inserted it will not turn, thus locking the steering wheel and vehicle in park. Try and ...
...ignition cylinder lock and have a key cut with correct chip, key that comes with lock will not start car only turn lock, you would take that key with old key and have one made,a quick test or to ...
Question about 1981 Corvette
...key will not come out of the ignition, any ideas what this could be? Hello You will need to get a new ignition because I believe that one of the inside tumblers have fell Causing the key to be stuck
Usually answered in minutes!
178 Questions
181 Questions
156 Questions
142 Questions
137 Questions
