Question about 2002 Grand Am
...key into the ignition cylinder. 2. Turn the ignition cylinder to ON (RUN) and back to OFF. 3. Remove the existing key and, within fifteen seconds, insert the new key and turn it to ON (RUN). 4. The ...
key into ignition,key dosent turn to start car Try moving the steering wheel slightly to the left or right when your trying to turn the ignition key's. If that does not work try the second set of keys
...key in ignition If you have two keys: - Insert the first programmed ignition key into the ignition lock cylinder and turn the ignition switch from OFF to RUN (maintain the ignition switch in RUN for ...
...ignition key b) faulty ignition lock c) steering column locking mechanism FYI - door locks operate with trunk key, not ignition key. Also, can remove ignition key with engine running. u can start but ...
key from ignition and then insert key into ignition without turning ignition cylinder and remove key. 5. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition. 6. Release
key into ignition, it does not turn Sounds like either your ignition is wearing out or your key is wearing out. First try another key, if it does the same thing it may be your ignition wearing out. If
Question about 2004 Aztek
...key/ignition area? What grinds ? the starter ? if so it's not a key / ignition area problem . If the starter didn't do anything it could be a key / ignition switch problem . It's sounds like you ...
Ignition Key The ignition key for vehicles which are equipped with the PASS-Key® II system consists of the following components: • A typical square ignition key blank • A resistor pellet The PASS-Key®
Question about 2004 Aztek
ignition key is used to turn the ignition lock cylinder to crank, start, a magnet on the lock cylinder passes close to the Passlock™ sensor within the ignition lock cylinder case. The magnet activates
Question about 2004 Aztek
key or ignition cylinder: Over time, the key or the ignition cylinder may become worn out, preventing the key from turning all the way to the off position. Electrical issue: There may be an electrical
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,496 Questions