Questions & Answers for: Hyundai Tiburon idling

Question about 2003 Tiburon

2 Answers

a car to idle high when you start up as lnog as it doesn't stay high you are ok. However, if it was idling too low that would be bad

Ad

Question about Motor 2000 Tiburon

1 Answer

wont rev past idle have a 2000 tiburon. it will start and idle fine but will not rev past idle unless i push the accelerator very slowly and let the revs slowly climb. it will go to redline if done ...

Ad

Question about 2003 Tiburon

1 Answer

sparatic idle only on cold idle Ok...how about on the cold start idle my car is starting to idle sparatically. The idle will go up and down...but when it drops to normal idle...it idles fine. Does ...

WHERE IS THE FUEL FILTER LOCATED ON A 2004 HYUNDAI TIBURON? WOULD ROUGH IDLING BE A SYMPTOM OF A BAD FUEL FILTER? 63,000 ORIGINAL MILES, ORIGINAL FUEL FILTER Usually plugged fuel filters and/or bad ...

Question about 2003 Tiburon

3 Answers

diagnostic codes p1505 p1507 ran stalled wont run turns over fine sorry but their are no diadnostic codes with this number in the manufacturers codes i have P0505....Idle Control System P0507....Idle ...

I have a 2003 Hyundai Tiburon Gt.When im coming to a stop and Im in neutral my car idles high.I can rev it up it drops back down to a 1,000 rpm's or where it should idle at. I have a 2003 Hyundai ...

My 2003 Tiburon GT V6 is sputtering at idle and sometimes goes up and then back to idle as well as going all the way back down to stall at times, it also sputters while trying to accellerate. I ...

Question about Motor 1997 Tiburon

1 Answer

while idling the car jumps The car will jump and the rpms will go up while idling While it is idling do you have your heater on or defrost on? If so the compressor will kick on making the car move ...

2003 hyndia tiboron gt it has 3 codes on it po102 and po507 and po507pd i have replaced the sensors 3 times and it has high idle when you hit the gas a little i gse from 1000 to 2500 it dose not have ...

2003 tiburon gt idles at 3000 rpms runs fine other than that only getting codes for o2 sensors replaced iac valve and tps already and no change i did have new header and exhaust installed with out ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...