Questions & Answers for: Honda CRF 150 F idle screw

...idle screw and the air screw on the outside throat of the carb must go back in the same locations they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until ...

Ad

...as long as i give it gas...it won't sit there and idle without dying. hi buddy on carb there 2 screws the big screw you need this is the idle screw you need to turn it in 1/4 of turns with bike ...

Ad

the carb srew under were the troddle cabel gose in i need to know the factory ajustment for the 2003 crf 150f there is not precised position you screw in for more idle and screw back for less.....

Question about 2004 CRF 150 F

1 Answer

...its 2 to 21/2 turn out from sit try adjusting the idle jet screw under in between bowl not the drain screw thats on the side of the bottom this is hiding between the bowl case i made the same ...

...idle screw d... 2004 150 runs good but won't idle and idle screw does'nt seem to make a differance well if it didnt run good i would say carburator needs cleaned or rebuilt.if bike performs fine you ...

Question about 2005 CRF 150 F

1 Answer

...idle set screw and reinstalled. (all the way in and then 1 and a half turns out) Now the bottom end works fine. Idles well and first half of the throttle is fine. As soon a you apply more throttle it ...

Question about 2005 CRF 150 F

1 Answer

idle screw and would dy, had at three shops and nothing solved, parked bike and has been in garage for over a year, sold it to a buddy for x- mas and bike still has same problem, check compression and

Question about 2004 CRF 150 F

1 Answer

idle screw to lower the rpm's? anticlockwise. but do not forget that if the throttle cable is tight, then this will hold the throttle open anyway. make sure there is some free play in the throttle

Question about 2007 CRF 150 F

1 Answer

...idle screw goes . Then it is fine once the bike is hot thew revs are really high. So then i drop the idle screw, then it is fine, after riding for a bit the revs usually are high once again. When i ...

Question about 2005 CRF 150 F

0 Answer

idle skrew back down to 950-1050 rpm If you can not detect any rpm change and can not stall the engine by turning the air-fuel mixture skrew all the way in then your pilot/low-speed jet is too big and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...