Questions & Answers for: Harley Davidson FXDL Dyna Low Rider idle screw

...idle mixture adjustment screw so we can adjust that for the best idle. Of course, you must take the carb off the bike and remove the float bowl and the diaphagm and piston. I'd also check the ...

carburetor backfire 97 dyna lowrider backfire can be caused by a too lean idle screw adjustment on the carburetor.

...with a carb. You may have to take the outer air filter cover off. Look at the top of the carb. Just to right of the round looking top is the idle stop screw. Clockwise to speed it up. Good Luck ...

screw that holds the switch in place, then re-solder the wires to the new switch. Lubricate the handlebar and the inside of the throttle sleeve with some thin grease and install it back into the lower

...Idle screw is on backside near front of carb but remember these Twin cams run on oil volume not oil pressure. The bike needs to idle between 1000 - 1200 rpm to maintain proper oil circulation. If you ...

runs great ticks over to fast when warmed up. dont know where idle screw is. ticks over fast when hot. where is idler screw. Need more info. What year and engine size? Carburetor or fuel injected?

...idle, turning screw counter clockwise will richen mixture and raise idle. You need to balance the two adjusting screws to obtain an idle of 950-1000 RPM then back out air/fuel mixture screw 1/4 turn, ...

...idle, turning screw counter clockwise will richen mixture and raise idle. You need to balance the two adjusting screws to obtain an idle of 950-1000 RPM then back out air/fuel mixture screw 1/4 turn, ...

a special CARBURETOR IDLE ADJUSTER and tip. Turn clockwise to increase idle speed and turn counterclockwise to decrease idle speed. The throttle stop screw in on the right or front side of the CV carb

...idle adjustment screw. It faces out towards the air filter end of the carb . The engine should be at operating temperature with the enrichener off to set the idle between 950-1050 rpm. Turn the screw ...