Questions & Answers for: Harley Davidson FLHR-FLHRI Road king idle screw

ajust my idel efi road king ON CARB THE IDLE SCREW TURN THIS IN 1/4 OF A TURN AT A TIME WITH THE MACHINE RUNNING

IDLE SCREW ON CARB TURN IN 1/4 OF A TURN WITH THE MACHINE RUNNINGINE STARTED Thats not a pic of a harley carb hahahahahaha. Take your air cover off and lower right side is a small hole thats where you

...screw driver goes in to adjust your idle. Ya the dealer has a scanlizer that can also do it if u want to spend the bucks. Idle speed on a fuel injected model has to be adjusted by a dealer. Or, get ...

...48 slow jet and probably a 180 main jet in it and the mix screw should be adjusted to give you a nice smooth idle with the bike warm and idling around 950 RPMs. Good luck and thanks for using ...

...screw the idle mixture screw inwards counting the turns as you go before removing), be sure to remove the washer and "o" ring with the mixture screw, sometimes they will not come willingly. Clean the ...

98 HD Road King carb. Bogs out at 60km Stalls at idle Not a lot of information to work from but my best guess is a bad accelerator pump diaphragm. If it coughs back through the carb when you try to ...

...idle, turning screw counter clockwise will richen mixture and raise idle. You need to balance the two adjusting screws to obtain an idle of 950-1000 RPM then back out air/fuel mixture screw 1/4 turn, ...

of the backing plate,and there will be a small hole. There is a small torx bit screw in that hole that you will need to turn to adjust the hot idle. Dont quote me,but i think its a t20 or t25 torx bit

where is idle screw on 05 road king flhr Hi Anonymous, it's the screw with the spring behind it, on the right side of carburator. Good luck

idle screw on 05 road king Hi Anonymous, the idle set screw is on the right side of carburetor it's a brass screw with a spring behind it. Also there is a cam stop screw where the ends of the throttle