Question about Pro 16-Inch 38 cc Anti-Vibration Chainsaw #PP3516AVX
...screw. At idle turn the screw in or clockwise until the rps starts to decrease. Then start turning it out till you hit max idle rpms. Turn screw back in a quarter to half turn and it should be idling ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...until it idles, may have to keep it running by giving gas and lettting off of gas until you find the correct idle speed you only screw it in till it moves the throttle plate. Now start it and set ...
start cutting. Allow to idle and adjust L for smooth idle, but rich enough to allow the engine to 'follow the throttle'. Set idle speed screw to just allow the chain to stop moving. clockwise for lean
...idle screw - usually larger - and turn in 1/2 a turn - hopefully that will keep it running - then find the 'slow' running screw turn it in until it stops then turn out 1 and 1/2 turns. Leave the fast ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...idle speed is the only problem, there is a screw (not the two jet screws H and L) for this purpose. Turn the screw CCW until the chain stops turning, but the engine continues to run. Hope this
...idle screw if it will not tick over, start to turn the L screw in, the revs will increase as the mixture leans off, it will reach a point where it is too lean and start to die, at that point turn the ...
...screw counterclockwise until the proper idle speed is reached. These screws are usually recessed in the housing on the left side of the saw, and may have an L and an H next to the holes. Be careful, ...
Question about 18" Wild Thing Chainsaw
...low mixture screw for highest idle,you may need to unscrew the idle screw a bit to keep revs down.adjust H mixture screw at full revs,to get max revs,then unscrew 1/4 turn.may need to reset ...
Question about 18" Wild Thing Chainsaw
on poulan pro 50 cc won't idle. Idle screw doesn't affect the speed do I need to increase or decrease low screw it runs good at high rpms adjust both till it runs perfect or set the idle screw up some
Question about 18" Wild Thing Chainsaw
...adjustment screws, an L screw an H screw and a T or I screw, the latter screw will be the idle speed screw, by screwing it in clockwise it will act against the throttle spindle increasing the
Usually answered in minutes!
583 Questions
457 Questions
255 Questions