Questions & Answers for: Ford idle screw

...idle on 1996 Ford Probe. Where is the screw? Just had the water pump and timing belt changed. Now my idle is screwed up - is staying at around 600 RPM's right now. ...

...idle screw. When you get to the point the screws no longer affect the idle the engine show sound and run smoothly at idle, make sure you resert the idle to 650rpms for an automatic trans and 650-750 ...

...idle adjust screw is found just near the throttle cable connector. Fine tune the idle by slightly adjusting the screw till the engine RPM ranges between 750-900. Then apply a pinch of quick fix ...

...idle setting loosen the lock nut and screw out the allen screw that it just touches the butterfly surface lock the nut / on top of the same unit you will find a phillips screw. screw this in just ...

...Idle screw is screwed in enough to allow the throttle to be open enough to idle. Hope this helps Thanks Jason The instructions given by the other expert are spot on. I suggest you follow those guides ...

...to limit the amount of adjustment) The choke adjustments; To adjust the vacuum tension pull on the choke pull-off: Adjust the fast idle screw to the proper RPM with the engine cold and the choke

the fuel ratio when running above idle, I have seen slots (screw driver) oval, hex screws, your going to have to see which one you have, take the air cleaner off and reach it from the front of the van

this properly, turn the engine on with the hood open. Keep the engine on and adjust the screw left or right until the RPM indicator points right above 1000 RPM. A good idle speed for a SUV is 1200 RPM

screw in or out to adjust idle. Often times a simple cleaning of that area will restore idle to its proper place. Some penetrating fluid and an old toothbrush to remove crud that has built up over the

...idle screw,could this cause any performance problems? what ,if any,performance problems could result from adjusting the factory idle screw? Should not be anything above idle speed. You might get ...