Idle Air Control (IAC) Valve Removal Disconnect battery ground cable (14301). Refer to Section 14-01 . Disconnect the engine control sensor wiring (12A581) from the idle air control valve (IAC valve)
...Idle Air Control valve) This is my opinion take it at face value. There are slight differences between the 3.0 liter and 3.8 liter. ...
Question about 1988 Crown Victoria
...idle air control vavlve located on a 1988 crown vic where is the idle air control valve located on a 1988 crown vic with a 5.0 liter fuel injected motor attached to the throttle body,looks like an ...
...motor. I keep getting a OBD2 code of P0411 which equates to secondary air injection incorrect upstream flow detected. What exactly does this mean and how do I repair it. check idle air control ...
...real high I have a 93 190e 2.3 liter 5 speed lately its been idling real high at around 2000 rpms. I was wondering what to check first? poss ur idle air control valve is dirty or bad check thaty ...
...gas sticking on high idle i changed the tps and map sensors and new vacuum lines check your idle air controller, they usually get a heavy carbon buildup on them and stick-easy to remove and
...Idle Air Control (IAC) Valve Replacing?http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html-----------Replace Idle air control valve? --------- Test Idle Air ...
...I didn't see any obvious air controller adjustment that I can make minor tweak prior consulting professional. there is no adjustment it is run by a sensor. it is called idle air control ...
Question about 1988 Ranger
...(idle air control ) these get cartooned up start sticking try tapping it lightly if idle changes pull it of clean it or replace it iac should two bolts and a 3-4 inch round cylinder on side of ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions