Question about 16" Chainsaw Bar Chain Saw 018 025 Ms 180 250
...turning if this is happening, then your chainsaw is just idling to fast, you need to turn down the idle speed a little. on the carby, there are 3 screws, 2 small (H), (L), and a larger screw is the ...
Stihl saw runs but won't idle. I have pulled the carb, cleaned and re-installed. The muffler was loose so I tightened it. I have tried to adjust the low speed adj but to no avail. I have a Husky ...
Question about Used Ms290 Ms 290 310 390 029 039 Flywheel
where do i set the idle scew at to start my ms 390 when i got the saw it wouldn't start.It floods out when i try to start it.Can you tell me where to set the idle? I wouldn't adjust the idle. ...
Question about Used Ms290 Ms 290 310 390 029 039 Flywheel
Stihl FS110R trimmer I can't keep it idling I can start it, run it, use it but it won't idle. increase the idle speed via the tuning screws on the carb
Question about Zama Fs-80 Carburetor C1q-s157 C1q-s63a C1q-s69a Wt-447 C1q-s28d C1q-s45
adjusting idle speed low speed idle adjustment idle speed is adjusted by the I underneath the LH screws
Question about 017 018 Ms170 Ms180 Chainsaw Starter Stbx759
chainsaw blade rotating when idling no adjustment left on carb. adjusting screw. Am unable to prevent blade rotating when idling without applying brake. Engine seems overrevving when idling. Could be ...
Question about 017 018 Ms170 Ms180 Chainsaw Starter Stbx759
Chain Saw Stihl 290 Farmboss wont idle well can keep the saw running,but wont idle on its own Check to see if the air filter is clean. If it is, increase the idle speed adjustment screw on the ...
Adjust idle on stihl chain saw Stihl chain saw stalls at idle. How do I increase idle speed? adjust it at the throttle end on the carby if you have the correct tool you can adjust the idle mixture as ...
Question about 017 018 Ms170 Ms180 Chainsaw Starter Stbx759
stihl BR 600 year ago no idle without flicking throttle became worse ran at 3/4 throttle no idle replace carb noticed throttle cable wont let carb return idle trigger screw is all the way out also ...
Question about 017 018 Ms170 Ms180 Chainsaw Starter Stbx759
...ms261c. After 20-30 min working, sometimes when I rapidly release the gas from full trottle to idle, it stops and I cannot start it anymore. Need to wait 1h or so then it starts. My Stihl won't ...
Usually answered in minutes!
61 Questions
59 Questions
27 Questions
22 Questions
19 Questions