husky 350 chainsaw idle to high how do I fix the idle,I see the low and high screws First there is an throttle idle screw that adjust the amount of throttle at idle try turning it ccw until it idles ...
19.5 hp rough idle. Galloping idle and at low rpm 19.5 hp Briggs and Straton has rough idle. Galloping idle and at low rpm Definately a Hard-D problem; replace it.
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
Reference the Husqvarna 350 chainsaw. Why does the chain continue to turn at idle? I just installed a new clutch. Adjusting the idle down causes the saw to shut off upon trying to accelerate. Sounds ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...and it's working pretty well out of the box. However, after cutting for a couple of minutes, the idle seems to get stuck, so that after I let off the throttle the chain is still spinning--if I had ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
how do you set the idle on the 353 saw. it will start and run but wont idle, then it shuts off. fire it back up and same happens There should be a idle screw adjustment on carb.if not try adjusting ...
cant find the idle screw Hi allenplum, There are 2 mixture screws, 1) the idle speed screw, 2) is the idle speed mixture screw. The idle speed screw is located on the carburetor, nar the throttle arm ...
Question about 136 137 141 142 Replacement Starter Pulley & Recoil Spring
why wont my saw idle you can tighten its idle screw next to where its throttle is and you should get it to idle
Saw will start but will not idle Carbeurator is clean, good spark. Saw was in storage and fuel lines were cleared. Just refueled with new fuel mix and she starts up great and will turn with the ...
Question about 435-BRC-RB Chainsaw
my 435 starts perfect but will not idle whats the problem carb settings are out of wack. try turning your idle screw up 1/8 of a turn at a time until it idles at a reasonable rpm and the chain not ...
Question about 435-BRC-RB Chainsaw
...badly when idling.Various things keep coming loose. Tried locktight. 2nd problem is slow to idle from full revs, sometimes won't idle, will cut out when turned chain side down. Could be a
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions