Questions & Answers for: ide by side

...jumper for Primary IDE at the end of data cable the first two pins (not side by side,opp ) short It is also wrritten on the HDD. pl try it Was this soultion useful?show ur appericiation by rating ...

dvd/cd-rom drives does not work make sure that your IDE cable and Power cable is plugged correctly. the Red side of the IDE cable must be parallel to the red side of the Power cable.

...side panel, you will find near the top of the machine the ide cdrom drive, and possible another cdrom or tape backup ide drive. Below those one or two drives is your hard drive (ide). To remove them, ...

...ide 2 can be used for your cd drive. Both connectors are 40 pin and are usually sited side by side on the board. Unfortunately you haven't given the make and model of the motherboard so the advice I ...

...here's what a sata hdd connection looks like here's what a IDE hdd connection looks like here's a page that shows them side by side Hopefully that should help with what you have

...IDE Cable Pull the side panel off of the computer case and set it aside. Locate the drive that you want to connect with a USB cable. Remove the screws holding the drive into the drive bay. Disconnect ...

side edge of the IDE cable for the faint Red stripe. This red stripe is on the same side as Number 1 pin. http://en.wikipedia.org/wiki/File:Nappe.svg So when you go to plug the IDE cable in, make sure

...IDE connector.Now look at the right side where it states - Power connectorWhen the IDE flat ribbon cable is plugged into the harddrive, the faint red strip faces - Power connectorOn the motherboard ...

...side of the flat ribbon IDE cable that has the faint red stripe on it, goes DOWN, when installed in the motherboard connector.If the DVD drive does not have a cutout for it's circuit board, the ...

...side of the flat IDE ribbon cable, http://en.wikipedia.org/wiki/File:Nappe.svg This stripe denotes the side, that number 1 wire is on. Motherboard installed in computer case, the red stripe on that ...